HiRO H50196 - Manual

C 2009 All rights reserved.
Microsoft, Windows, Windows Vista and PowerPoint are registered trademarks of Microsoft
Corporation. Other trademarks and registered trademarks are used herein for identification
purpose only and belong to their respective companies.
Trademarks:
Wireless Media Presenter
IMPORTANT SAFETY AND HEALTH INFORMATION
LASERSTRAHLUNG – AUGENKONTAKT M IT DEM L ASERSTRAHL V ERMEIDEN
LASERKLASSE 2
( A C H T U N G ! ) WARNING! RISK OF INJURY!
Laser beam can cause permanent damage to eyes. Do not look
into the laser beam or shine the laser beam into your eyes, other
peoples' eyes, or pet's eyes.
WARNING! RISK OF INJURY!
Keep this device away from Children. This is a working tool, not a toy or entertainment device.
It should only be used by adults.
ExpressCard Form Factor
FEDERAL COMMUNICATIONS COMMISSION
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiated radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user‘s authority to operate the equipment.
This device and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter.
Frequency range: 2400~2483MHz(16 channels and 65535 ID per channel)
Remote range: Up to 130 feet (40 meters) line of sight
Operating voltage: Remote control 2.6V~3.3V
Power: CR2032 battery * 1
Very low power consumption:Normal operation < 5mA
Laser operation <30mA
Sleep < 10uA
Output power: Under 1mW
Size: 75(l) x 34(w) x 5(h) millimeters
Presenter weight: Approx. 13.6 grams (with the receiver and battery)
PCMCIA adapter tray weight:Approx. 7grams
Operating Temperature : 0℃(32℉)~60℃(140℉)
Operating Humidity(non-condensing) : 10%~85% RH
Note: Design and specifications are subject to change without notice.
Product Specifications
What's included
Introduction of Wireless Media Presenter
Wireless Media Presenter (with USB receiver in the back)
CR2032 Battery
User's Guide
PCMCIA Adapter Tray x 1
x 1
x 1
x 1
Stop going back to your computer again and again during your presentation or listen
to your music, the Wireless Media Presenter integrates laser pointer, multimedia and
PowerPoint controls into an ExspressCard form factor remote control device. It can be
conveniently stored in the ExpressCard slot, y
so you always have it when needed.
The Wireless Media Presenter is designed by the advanced RF technology, no IR
line-of-sight limitations, no software required, just plug and go!
ou can also use the supplied PCMCIA
adapter tray to fit it in your PCMCIA card slot,
Ex pr es sCar d/ 34 slot or
Ex pr es sCar d/ 54 slot PCMCI A car d slot
System Requirements & Software Compatibility
Windows® 2000 / XP / Vista / 7
An available USB port.
Doc No.: EB-B6230-201 Ver.D
Information in this document is subject to change without notice. No part of this document may be
reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose,
without the express written prior permission of the seller.
The seller provides this document without warranty, or condition of any kind. The seller may make
improvements or change in the product described in this documentation at any time.
Other product and company name herein may be the trademarks of their respective owners.
RoHS