Humanscale CPU555SEC - Manual

CPU555, CPU555SEC
Installation Instructions
CPU555 CPU555SEC
a. Remove nuts from
extension bracket. Leave
washers on posts. (a)
c. Screw rubber bumpers
onto extension bracket. (c)
b . Unscrew rubber bumpers
from CPU555. (b)
d. Slide extension bracket
over threaded posts.
Tighten down with nuts. (d)
1b. For CPU555SEC Installations,
Attach Security Brackets to Holder
Place Security Brackets on top of Bottom Support as shown. Insert Spacer
between Security Brackets and Bottom Support and position over center
hole for CPUs 5"-7" wide (for narrower CPUs, use one of the inner holes, for
wider CPUs, use one of the outer holes.) Insert Screws into top of Security
Bracket as shown and fasten loosely with Security Nuts.
Security
Brackets
Bottom
Support
Spacer
Security Nuts
1-1/2" Screw
3/4" Screws
1a. Assemble CPU555
For CPUs Wider than 6”
Adjust width of Bottom Support by
loosening Knob under Bottom Support
and sliding Outer Bracket to width of CPU
or to fully extended position as desired.
Retighten Knob.
For CPUs 3” to 5” Wide
Install extension bracket.
(a)
(d)
(c)
(b)
Outer
Bracket
Knob
1 of 2