INCRA T-Track Plus w/Scale - Manual

Mounting Options:
Use the supplied #8 x 1 ⁄ 2 ” pan phillips wood screws to
mount your track using one of the following options:
T-TRACK +
®
Surface
Mount
Use the supplied
fasteners to attach
to your application.
1
Flush Mount
A. Groove
Cut a groove
1 ⁄ 2 ” deep by
1 1 ⁄ 4 ” wide
to accept the
track.
2
B. Build-up
Use 1 ⁄ 2 ” thick
material on
either side
of a surface-
mounted track
to create a
flush mount.
T-slot
Mount
Use standard
1 ⁄ 4 -20 fasteners
(user supplied)
to attach via the
T-slot located
under the scale.
3
Workbench
■ Use T-track
PLUS in your
workbench top
to easily locate
your favorite
clamping fixture.
Jigs & Fixtures
■ Use T-track
PLUS to position
a hold-down to
specialty jigs and
fixtures.
Drill Press
■ T-track PLUS in
your drill press
table lets you
position and
lock down the
fence as well as
clamping fixtures.
T-track PLUS in
the fence locates
and locks a stop
positioner in
place.
Applications:
Attach stops, guards, jigs, fixtures and hold-downs. Use
your INCRA T-track PLUS on the workbench or drill press.
Upgrade your
Miter Gauge
Fence
■ Front-mounted
T-track PLUS lets
you position a
stop, while rear-
mounted track
lets you slide
fence left or right
on your miter
gauge.
T-TRACK +
®