Big Game Treestands Big Game Tree Seat CR91169 - Manual

TREE SEAT
ASSEMBLY & INSTALLATION
CR91169
Ultimate Swivel
TS96-VS
Slimline
PO Box 382 • 1820 N. Redding Avenue • Windom, MN 56101
Toll Free: 800-268-5077 • Website: www.biggametreestands.com
WARNING: Tree Seats are to be used at a height that allows the feet to be on
the ground at all times when in use. Use as a ground seat only! Failure to follow
this warning may result in serious injury or death!
Figure 1 Figure 2
CR91169 ASSEMBLY
INSTRUCTIONS:
1. Remove 2" nut, bolt, and
washers from the mainframe.
2. Making sure the strap is facing
inward (toward the seat),
insert post into grove on
mainframe.
3. Reinsert bolt, washers and
nut. Tighten securely.
INSTALLATION - ALL SEATS:
1. Position seat in closed position (see fig. 1).
2. Place strap around tree (see fig. 1).
3. Place buckle over S-hook (see fig. 2).
4. Pull strap through slide buckle until tight.
5. Lower seat into sitting position (see fig. 2).
6. If seat becomes loose, lift seat upright and
retighten strap.
TO REMOVE:
1. Lift seat to upright position.
2. Loosen by sliding strap back through buckle.
3. Remove seat from tree.