I.R.I.S. 507 - Manual

IRIS506/507/517 Fitting and Operating Instructions.
The IRIS5xx Series control unit and remote keyboard is a PTZ controller designed to be used to operate
the Pan Tilt and Zoom features of IRISʼs range of marine PTZ and Thermal PTZ cameras.
The controller sends RS485 serial data to the camera and is preset to transmit data using the Pelco D pro-
tocol at a baud rate of 9600bps.
The IRIS5xx Series can also control third party PTZ devices but must be configured accordingly. For more
information contact Iris Innovations or your Iris dealer.
IRIS5xx Series Contents:
The IRIS516/517 is shipped with the following components. Ensure theses items are included in the pack-
aging:
1. Controller Unit
2. Joystick Unit
3. Power Cable Tail
4. Data to Camera Cable Tail
5. Joystick Cable (2m CAT5 STP Cable)
6. Fixing Template
Fitting Guidelines:
1. Consider where the joystick is going to be installed and the proximity of the Joystick to the Controller
Unit. The Joystick must be installed no further than 2 meters from the Controller Unit.
2. Use the Fixing Template to drill the 4 x 5mm screw clearance holes and to cut the 65mm hole required
for the body of the Joystick Unit.
3. Ensure correct orientation of the Joystick Unit and fit into place. It is recomended that a silicone sealant
(such as Sikoflex) be used on the underside of the Joystick Unit bezel if mounting externally to prevent in-
gree of water.
4. Find a suitable position for the Controller Unit (no greater than 2 meters from the Joystick Unit) and fix
into place using appropriate fixings. Connect the Controller Unit to the Joystick Unit using the 2 meter CAT5
STP cable (supplied). The controller unit must be located internally away from moisture.
5. Connect the serial data feed to the camera using the cable tail supplied. The camera data cable can be
identified by the 3 pin connector. Ensure correct polarity. If, following installation, the camera doesnʼt re-
spond to joystick operation, switch the polarity of the data pair.
6. Connect the power supply to the power cable tail supplied. Ensure correct polarity is observed. Connect
+12VDC to the Red core, and GROUND to the Black core. Ensure the power supply to the Control Unit is
safely isolated using a suitably rated fuse of preferrably, circuit breaker. The Cntroller Unit is rated at
12VDC ~ 1A.
Operation:
Once correctly installed and powered up, use the joystick to drive the camera by moving in the desired di-
rection. To Zoom IN , twist the Joystick head Clockwise and to Zoom OUT twist anti-clockwise.