Landoll 6K273 (Soil Commander II) - Manual

3K915 (Soil Commander I)
& 6K273 (Soil Commander II)
INSTALLATION INSTRUCTIONS
REAR HITCH KITS
Place the rear hitch on top of the Soil Commander frame and position as shown in the drawing below.
Place 4J412 straps on the underside of one Soil Commander frame member and assemble loosely
with 5/8 X 8” machine bolts, lock washers, flat washers, and nuts. Then assemble likewise to the
other Soil Commander frame member.
Square up the entire assembly on the machine and tighten all fasteners.
With the rear hitch kit installed, the Soil Commander becomes “drawbar light.” Plates 3K955
and U-bolts are provided for mounting to the front of the 4” X 4” tube on the Soil Commander
drawbar. See instructions drawing on reverse side. Tractor weights (not provided) can be
attached to these plates to achieve the desired weight distribution.
3K954 0513
REAR
SOIL COMMANDER
FRAME MEMBER
SOIL COMMANDER
FRAME MEMBER
SOIL COMMANDER
FRAME MEMBER
5/8” X 8” MACHINE BOLTS
5/8” LOCK WASHERS
5/8” FLAT WASHERS (ON TOP SIDE, AGAINST SLOTS)
5/8” HEX NUTS