Lenze 8400 - Manual (Page 301)

Appendix
Total index
12

301 EDS84ASC552 EN 9.1
12 Appendix
12.1 Total index
A
Accessories, 286
- External brake resistor, 250
Analog inputs, 78, 81
Analog inputs and outputs, 223, 230
Analog outputs, 78, 81
Application as directed, 271
Application, as directed, 271
Assembly
- standard installation, 89, 112, 138
- standard technique, 90, 112, 139
Axis bus
- CAN, 84, 239
- Sync/State, 84, 239
B
Baud rate, System bus (CAN). Siehe Baud rate
Brake resistor, 254
- Selection, 253
- Wiring, 256
Braking, 249
Braking operation, 249
- DC injection brake DCB, 249
- With external brake resistor, 250
- without additional measures, 249
Bus cable length, 216
C
Cable
- For control connections, 170
- for the motor connection, 169
Cable cross-section, 217
Cable specification, 214
Cables
- cross-sections, 38, 45, 52, 56, 60, 65
- fuses, 38, 45, 52, 56, 60, 65
”Cold Plate”, requirements for the cooler, 103, 129, 148
Commissioning, 241
- analog inputs and outputs, 223, 230
- before initial switch-on, 241
Commissioning steps, 245, 247
Communication modules, 294
Compensation equipment, Interaction with, 159
Configuration, Display functions, 265
Contactors, in the motor cable, 18
Control cable, 170
Control terminals, 77, 80, 209, 222, 228
- TopLine C, 84, 237
D
DC bus, connection to the, 195, 205
DC supply, 168
DC-bus operation, 28
Definition of notes used, 11
Definitions, Terms, 10
Device protection, 18, 209, 293
Diagnostics, 221, 265
Digital inputs, 79, 82, 226, 233
- StateLine C, connection of an HTL incremental encoder,
227, 235
Digital outputs, 79, 82, 226, 233
Display
- Operating status, 265
- operating status, 265
Display functions, 265
Disposal, 14
Drive behaviour, Influence of the motor cable length, 159
E
Electrical installation, 153, 283
EMC
- Accessories, 299
- what to do in case of interferences, 175
EN 61000-3-2, 31
Encoder, 238
F
Fuses, 38, 45, 52, 56, 60, 65
- operation with rated power, 400 V (UL), 38, 39, 45, 46,
52, 53, 56, 60, 61, 65, 66