Lightforce LED 180 - Manual

KIT CONTENTS:
1 x LED 180 light
1 x Clear filter (fitted to light)
1 x Mounting bracket
3 x M10 x 35mm stainless steel bolts
2 x M10 small stainless steel washers
1 x M10 large stainless steel washers
1 x 2 pin Deutsch waterproof connector
1 x User instructions
INSTALLATION GUIDE:
TOOLS REQUIRED:
• 17mm socket on ratchet
• Torque wrench
GENERAL CARE AND SAFETY TIPS:
To wash your lights, use plenty of warm soapy water and a soft cloth only (this prevents the surface from marking). If cleaning
the INSIDE face of your filter, use copious amounts of water and a soft cloth.
CAUTION:
Never use any solvent based cleaners or industrial detergents when cleaning your lights.
Image 1 Image 2 Image 3
MOUNTING:
LED 180 can be mounted in three different positions (two cross-bolt holes and a reversible mount; see picture)
Before fitting the mount, insert the mounting bolt then select the most suitable position for your application.
LIGHTFORCE LED180
LIGHTFORCE AUSTRALIA PTY LTD • 28 Orsmond Street, Hindmarsh SA 5007 Australia • www.lightforce.com | email: [email protected]
Australia: Tel: 08 8440 0888 | Fax: 08 8346 0504 • Int’l: Tel: +618 8440 0888 | Fax: +618 8346 0504
All logos and images are subject to relevant trademark and copyright protection LIGHTFORCE Pty Ltd | © June 2014 • Data and specifications contained maybe subject to change without notice.
LIGHTFORCE Australia Pty Ltd shall not be liable for damage, malfunction, failure resulting from accident, misuse, misapplication, unauthorised repair, neglect, modification, unauthorised or non standard replacement parts,
accessories, bulbs, batteries or voltage or operation of the product beyond its technical and or environmental specification.
INSTRUCTION DATA
PRODUCT: LED180
VER: 1.1
DATE: JUNE 2014