Lightforce SUPPORT-A-LIGHT - Manual

LIGHTFORCE AUSTRALIA PTY LTD • 28 Orsmond Street, Hindmarsh SA 5007 Australia • www.lightforce.com | email: [email protected]
Australia: Tel: 08 8440 0888 | Fax: 08 8346 0504 • Int’l: Tel: +618 8440 0888 | Fax: +618 8346 0504
All logos and images are subject to relevant trademark and copyright protection LIGHTFORCE Pty Ltd | © Oct 2006 • Data and specifi cations contained maybe subject to change without notice.
LIGHTFORCE Australia Pty Ltd shall not be liable for damage, malfunction, failure resulting from accident, misuse, misapplication, unauthorised repair, neglect, modifi cation, unauthorised or non standard replacement parts,
accessories, bulbs, batteries or voltage or operation of the product beyond its technical and or environmental specifi cation.
INSTRUCTION DATA
PRODUCT: SUPPORT-A-LIGHT
VER: 2.0
DATE: MARCH 2008
SUPPORT-A-LIGHT INSTRUCTIONS
Support-a-light bracket consists of 8 components
as illustrated.
Tighten tri-screw (male) (1) securely through top plate
(2) to shaft (3).(do not over tighten).
There are 3 easy locating positions for the top plate on
shaft – facing front, centre or back of vehicle.
Secure top locating rail (5) through shaft (3) using
tri-screw (female) (4) - do not over tighten.
Recommended locating hole is second hole from top of
shaft.
Insert gas strut (7) into shaft (3) using strut locating
bolt & nut (6) – recommended locating hole is second
from bottom (adjust accordingly to size of window).
Attach locating bottom rail (8) to bottom of gas strut
(7).
If remote handle is too high or too low in window frame,
you are able to adjust the height simply by altering
the position of the top locating rail up or down in the
top three holes of shaft and adjusting gas strut to suit
accordingly.
PERFORMANCE LIGHTING
1
6
2
3
4
5
8
7
If interior trim is higher than exterior door frame:-
Place the bottom locating rail of bracket between glass and external
weather strip of door frame.
If exterior door frame is higher then interior trim:-
Place the bottom locating rail of bracket between glass and interior trim.
If both the interior trim and extrerior door frame (weather strip) are
level, place locating rail of bracket on either side of the glass.
Locating
rail of
bracket
Interior
door
trim
Retracted
Glass
Exterior
door
frame
Weather strip
CORRECT INCORRECT
Window Locating Instructions