Lowell 30HRK - Manual

REMOVABLE
PHOENI X
CONNECTOR
Instruction Sheet
P/N: 20147
Issued: 9-10-14
Lowell Manufacturing Company 100 Integram Drive Pacific, Missouri 63069 U.S.A.
Call: 800-325-9660 Fax: 636-257-6606 Click: www.lowellmfg.com
30HRK
INSTALLATION SHEET
The 30HRK half-rack mounting kit allows the installer to mount
the Lowell MA30 mixer/amplifier in a Lowell half-size equipment
rack such as the Lowell LHFR-814 or LHFR-1214.
Step 2
2 Remove the two (2) chassis cover screws as shown in figure .
Also remove the same two (2) cover screws on the opposite side
of the chassis.
Screw Note:
The chassis screws that you removed, have a unique metric size
and thread pitch. Discard those screws. Provided with the kit are
8-32 self-tapping and 6-32 self-tapping screws that will use the
existing metric threaded holes as starter holes and will thread
new tapped holes that will securely attach the mounting brackets .
1
Step 1
The 30HRK half-rack mounting kit includes two (2) brackets, four
(4) 8-32 self-tapping screws, and four (4) 6-32 self-tapping
screws as shown in figure .
1
Step 3
3
Line up a bracket with the holes in the MA30 and securely tighten
the two (2) 8-32 self-tapping screws and the two (2) 6-32 self-
tapping screws where shown in figure .
Step 4
4
Line up the second bracket with the holes on the opposite side of
the MA30 and securely tighten the two (2) 8-32 self-tapping
screws and two (2) 6-32 self-tapping screws. The completed
assembly with the half-rack mount brackets installed is shown in
figure .
Step 5
Finally, mount the MA30 mixer/amplifier in a Lowell half-rack
using standard 10-32 Phillips-head machine screws (like the
Lowell model RS or RSP rack screws) with integral plastic
washers to protect the finish on the front of the mounting brackets.
Rack mounting screws are not included with the 30HRK kit.
1
4
2
3
8-32 black self-tapping screws
6-32 black self-tapping screws
Remove
Remove