Mark Feldstein & Associates Flameless LED Taper Candles - Set of 2 with Timer - Manual

Flameless LED Taper Candles With Timer Instructions
Battery Installation
1. Unscrew/remove the LED Bulb located on the top of the Taper Candle.
2. Insert 2 “AA” batteries (not included) into the compartment making sure the
positive (+) end on the batteries are inserted facing the bulb at top of candle.
3. Gently screw the LED Bulb back onto the Taper Candle about ¾ the way tight.
ON/OFF Operation
To turn Taper Candle on, tighten the LED Bulb until light comes on. The Automatic
Timer function will turn bulb on for 6 hours and then automatically turn off for a period
of 18 hours. If the bulb is kept in the same tighten position, the light will automatically
turn on and off at the same time each day. To manually turn off, loosen the bulb until
light turns off.
Please note that Taper Candle can be used on a table top, mantel, or windowsill. It can
also be attached to a window using the included suction cup. Please moisten the suction
cup before attaching candle to a window.
Battery Notice
1. Do not mix old and new batteries.
2. Do not mix alkaline, standard (Carbon-Zinc) or rechargeable (Nickel Cadmium)
batteries.
3. Remove batteries if candles are left unused for long periods of time.
4. Clean the battery contacts prior to battery installation.
5. To avoid leakage or explosion, do not put batteries in fire.
6. Dispose of batteries properly.
Mark
Feldstein & Associates, inc.
www.markfeldstein.com