Mark Feldstein & Associates Animated Christmas Trees User Manual

Mark Feldstein & Associates Toys

Advertising
background image

Animated Christmas Tree Instructions



ATTENTION:
Batteries are included for demonstration, and not intended as part of the purchase price of the product. It is
recommended that they should be replaced with 3 “AA” size batteries at time of purchase. Replacing the
batteries is recommended only under adult supervision.

BATTERY INSTRUCTIONS:

1. Lift battery case cover at bottom/back of product or open pouch and reach inside for battery box.
2. Loosen screws on battery box and lift cover off.
3. Insert 3 “AA” size batteries into the battery box making sure the battery polarity (+/-)
is as indicated.
4. Place battery cover back on battery box and tighten screws.
5. Carefully place battery box back into battery pouch. Your product is ready to be used.

ANIMATED CHRISTMAS TREE OPERATION:

1. To turn Animated Christmas Tree ON, squeeze left hand.
2. To turn Animated Christmas Tree OFF, squeeze left hand again.

IMPORTANT BATTERY INFORMATION:

1. Only use alkaline standard (Carbon- Zinc batteries. Do not use rechargeable (Nickel Cadmium)
batteries.
2. Do not mix old and new batteries.
3. To avoid leakage or explosion, do not put batteries in fire.
4. Remove the batteries if product is to be left unused for a long time.
5. When the product is not working or the sound is weak and distorted, the batteries
need to be changed.
5. Clean the battery contacts prior to battery installation.
6. Dispose of batteries properly.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital devices,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and the receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.




Mark Feldstein & Associates, inc.

www.markfeldstein.com

Advertising