Black & Decker SM511 - Manual

SM427 | Bicycle Handlebar Mount with Universal Holder
Package Contents:
(1) SM050-2 Universal phone and portable device holder
(1) CM011-2 - Sun visor mount
SM050-2
Universal Phone
Holder
SM511 |
Slim-Grip™ Universal Holder with Auto Sun Visor Mount
82 mm
expandable to
118.5 mm
Compatible with most smartphones, mobile phones, and cell phones having •
heights between 80mm and 115mm tall
Apple iPhone - All models
•
RIM BlackBerry - All non-fl ip models •
HTC Phones - All non-fl ip models •
Motorola Phones - All non-fl ip models •
Nokia Mobile Phones - All non-fl ip models •
Palm - All non-fl ip models •
LG Mobile Phones - All non-fl ip models •
Samsung - All non-fl ip models •
Sony Ericsson - All non-fl ip models •
Sanyo - All non-fl ip models •
Pantech - All non-fl ip models •
Google - All non-fl ip models •
Secure holder with your hand for support, as spring-loaded
mechanism requires signifi cant force to operate. Hold your phone
and insert into universal holder by pushing down on the bottom
spring-loaded support legs with moderate amount of pressure
(C). Slide the top of the device under the top support legs (D) until
it fi ts snuggly in the holder.
Insert Phone into Holder
D
C
Step 1.
A
A
A
A
B
B
Install the Support Legs to the Holder
Step 1. Insert the holder support legs (A) by sliding them into the
support leg grooves (B) on the top and bottom of the holder.
Continued on other side...
!
Safety Precautions
Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and / or
air bag deployment.
Arkon is not responsible for any damages caused to your car, your
device, or yourself due to the installation or use of this pedestal mount.
*All brand names and product
names are trademarks or registered
trademarks of their respective owners.
CM011-2
Sun Visor Mount
! Note: Arkon strongly recommends using the visor mount
on the passenger side sun visor. Using this mount on the
driver’s side visor will reduce the driver’s view of the road.
Do not place device car charger cords in or near an air bag
deployment zone.
Sun Visor Mounting
Lower the vehicle sun visor and place the clip mount over
the top of the visor. Slide the mount left or right to adjust
the location on the visor. Step 1.
Connect the dual T-slots (A) on holder to the dual T-tabs (B) on
the sun visor mount.
B
Connecting the Slim-Grip™ Holder to Dual T-Tab Mount
Step 1.
A
Consumer Hotline:
USA (800) 841-0884
INT’L (626) 254-9005
Monday - Friday 9 am - 5 pm, PST
Designed in USA | Made in China And Taiwan
© Copyright 2010 Arkon Resources, Inc.
www.arkon.com
Arcadia, CA 91006 USA
Representative in KOREA
www.knctek.com
TEL : 02) 839-5701
FAX : 02) 830-5703
࣬ ৹ࢄߔ޺੦