Brother NC9100H - Manual (Page 50)

CONFIGURING INTERNET PRINTING FOR WINDOWS ® 5 - 4
Brother Internet Print: Using BRAdmin
Professional utility to Configure the Print Server
The steps required to configure the Print/Fax server to receive print
jobs from a Windows
® 95/98/Me/2000/XP and Windows NT ® 4.0 PC
running the BIP software are as follows.
1 Start BRAdmin Professional utility.
2 Select the node name of the desired Brother Print/Fax server
from the list and double click on it. (the default node name is
usually BRN_xxxxxx, where xxxxxx is the last six digits of the
Ethernet address (MAC address)). You will be prompted for a
password; the default password is access.
3 Click on the POP3/SMTP tab.
4 Enter the address of the POP3 server (consult your network
administrator if you do not know this address).
5 Enter the mailbox name for the remote Brother Print/Fax server.
Usually this will be the first part of the E-mail address (for
example, if the E-mail address of the print server is
emailprinter@xyz
, then the mailbox name would be
emailprinter ).
6 Enter the password for the mailbox, if any.
Skip this section if you wish to use the Web Browser to
configure the Print/Fax server.
Using the BRAdmin Professional utility, you can configure
the Brother print server using the TCP/IP protocol, or the IPX
protocol.
You can find the node name and MAC address by printing
out the machine configuration page. For information on how
to print the configuration page on your Print/Fax server, see
Resetting the Print/Fax Sever back to factory settings (Test
Switch) on page 13-4.