Brother NC9100H - Manual (Page 70)

NOVELL NETWARE PRINTING 6 - 13
12 Change context if necessary and select the print queue you
created. Click OK and then OK again, and then exit NWADMIN.
13 Start the appropriate BRAdmin Professional utility, and select
the correct Print/Fax server you wish to configure (by default,
the node names is BRN_xxxxxx, where xxxxxx is the last six
digits of the Ethernet address (MAC address))
14 Double click the appropriate Print server. You will be prompted
for a password, the default password is access.
15 Now select the NetWare tab.
16 Select Remote Printer as the Operating Mode, select the name
of your PSERVER NLM as the Print/Fax server Name and select
the number of the printer from step 6 as the Printer Number.
17 Click OK. And exit BRAdmin Professional utility.
You must now unload the PSERVER NLM from your NetWare file
server console and then reload it in order for the changes to take effect.
Other Sources of Information
1 Visit http://solutions.brother.com/ for more information on
network printing.
2 To learn how to configure the IP address on your machine, see
Chapter 11 of this User’s Guide.
You can find the Node name and MAC address by printing
out the machine configuration page. For information on how
to print the configuration page on your Print/Fax server, see
Resetting the Print/Fax Sever back to factory settings (Test
Switch) on page 13-4.
The same service assigned by NetWare Print server cannot
be used for both queue server mode and remote printer
mode. If you want to enable remote printer capabilities on a
service other than the default NetWare service, you must
define new services that are enabled for NetWare and for the
desired port.