MB QUART MX-4 - Manual (Page 4)

INSTALLATION
ASSEMBLE TOOLS AND ACCESSORIES:
PLAN YOUR SYSTEM LAYOUT:
IMPORTANT GUIDELINES:
PLACEMENT AND MOUNTING:
Wire Cutters/Crimpers/Strippers
Prior to installing your MX-1, be sure that you have identified a good mounting location that will allow for easy access
to make adjustments. Determine the best routes for your wires and lay them out before permanent installation.
In most applications, mounting the MX-1 module close to the amplifier is ideal. Once the mounting location is
determined, mark the 4 mounting holes with a marker. Prior to pre-drilling the holes, ensure that there are dangers
on the other side of the metal. Once the holes have been pre-drilled, clean the metal shavings from the area and
mount the MX-1 into location.
Digital Multi-Meter
Supplied Screws
Supplied Allen Wrench
Small Flathead Screwdriver
Wrench For Battery Post
Drill With Phillips Bit
1/8” Diameter Heat Shrink Tubing
18 Gauge Power Wire(Application Appropriate Length)
18 Gauge Ground Wire(Application Appropriate Length)
18 Gauge Remote Wire(Application Appropriate Length)
- Read the entire manual prior to attempting the installation.
- Run all RCA’s so that they are far from any high current wires.
- Always inspect an area prior to drilling. Avoid cutting or drilling into electrical wires, fluid lines and gas tanks.
- All power wires connected to the front battery should have the appropriate fuse in line within 12” of the battery
terminal.
- The ground connection integrity to the chassis is very important. The best way to achieve a good, solid electrical
and mechanical contact is to use a large round crimp lug, crimped and soldered to the ground wire. Then scrape
or sand the paint off of the vehicle chassis, slightly larger than the ground lug, at the connection point. Drill a
clearance hole in the chassis, the same size as the lug hole, and use a bolt, spring washer and nut to securely
fasten the ground lug. Use petroleum jelly to coat the bolt/lug connection to prevent oxidization with time.
SUBWOOFER
INPUT
LEVEL
40V 4V
SUBWOOFER
OUTPUT
LEVEL
1V 9V
LOW PASS
FILTER
24 dB/OCT
250Hz 35Hz
BOOST
PARAMETRIC BASS EQ
BANDWIDTH FREQUENCY
+10 dB 100Hz 0dB 30Hz
SUBSONIC
FILTER
24 dB/OCT
35Hz 15Hz
MX-1
LINE LEVEL
CONVERTER
REAR HIGH
PASS FILTER
12 dB/OCT
200Hz 15Hz
FRONT HIGH
PASS FILTER
12 dB/OCT
200Hz 15Hz
FRONT & REAR
STEREO OUTPUT
LEVEL
4V 9V 40V 4V
HIGH LEVEL
F & R INPUT
CONTROL
4 CH MONO / HIGH LEVEL
SUBWOOFER
INPUT MODE
SELECTOR
GREEN: PRE-CLIP
YELLOW: SOFT CLIP
RED: HARD CLIP
CLIPPING CONTROL
2