MK Diamond 24" Cutting Kit - Manual

24 Inch Cutting Kit Revision 02/01, Effective Date February 7, 2001 Page 1
24-INCH CUTTING KIT (Document Part Number 158364)
The 24-Inch Cutting Kit modifies the MK-101 Series Tile Saws allowing the saw to cut tile up to 24 inches.
NOTE: If problems arise during the installation of the 24-Inch Cutting Kit, contact the MK Diamond Service
Center – (800) 474-5594
CONTENTS:
one (1) 24-inch frame, one (1) replacement shaft, one (1) shaft extension, one (1) adjustment knob extension,
two (2) retaining thumbscrews, two (2) carriage bolts, two (2) flat washers, two (2) wing nuts.
24 Inch
Frame
Replacement
Shaft
Shaft
Extension
Adjustment Knob
Extension
Retaining
Thumbscrew
Carriage
Bolts
Flat
Washers
Wing
Nuts
Tools Needed:
Blade Wrench or
9/16-inch Wrench
3/8-Inch Allen
Wrench
Preparation:
(A)
Remove Tile Saw
from Power Source
Disconnect Saw
(B)
Remove the Cutting Head
(See Tile Saw Owner’s Manual)
Remove
Cutting Head
(C)
Adjust Cutting Head Post for
maximum cutting length
(See Tile Saw Owner’s Manual)
9/16-inch
Wrench
- OR -