MK Diamond TX-3 Manufacturer Water Pump User Manual
Tx-3 tile saw, Manufacturer water pump modification
www.mkdiamond.com
TX-3 Tile Saw
Manufacturer Water Pump Modification
Part# 164800-IS
March 16, 2010
1. Pre-start Inspection:
Prior to beginning work, a pre-start inspection of the pump should be performed. Inspect the Pump
Assembly for damage—ensure the cord is free of cracks or cuts.
2. Water Pump Preparation:
Install Water Pump
Discharge Fitting.
Press one end of the Cooling
Transfer Tube onto the Water
Pump Discharge Fitting.
Slide Cooling Flow Adjusting
Clamp onto the Cooling
Transfer Tube.
3. Water Pump Setup for Operation:
NOTE: If using a dry blade for operation, DO NOT connect the water pump.
Loosen clamp and remove
existing cooling tube from inlet.
Remove cooling tube from guides
and secure near rear of motor.
Install new cooling transfer
tube by sliding through guides
to front of the saw
Install cooling tube to inlet.
Tighten clamp.
Connect the water pump power
cord to receptacle.