Connecting the sonar display to motor, Stowing and deploying the trolling motor, Stowing the motor – MotorGuide Wireless User Manual
Page 20: Warning, Caution
Section 4 - Trolling Motor Operation
Page 16
90-8M4002601
eng
JUNE 2010
Connecting the Sonar Display to Motor
NOTE: This sonar display connection procedure applies to the Wireless Series motor that offers built‑in 200/83 kHz sonar
transducers compatible with Eagle
®
, Garmin
®
, Humminbird
®
, Lowrance
®
, and Vexilar
®
brand sonar displays. Wireless sonar
models connect with Lowrance 6 pin sonar units. For compatibility with other sonar units, refer to www.motorguide.com.
Match the cable connector to the sonar port on the back of the sonar display. Power up the unit to ensure that the sonar cable is
connected securely.
a -
Harness to nose cone sonar
b -
To 12 VDC source, if required
c -
To graph display
Stowing and Deploying the Trolling Motor
!
WARNING
Rotating propellers can cause serious injury or death. Never start or operate the motor out of water.
!
CAUTION
Moving parts, such as hinges and pivot points, can cause serious injury. Keep away from moving parts when stowing, deploying,
or tilting the motor.
Stowing the Motor
1. Firmly grasp the column with one hand and then pull up on the release handle with the other hand.
a -
Release handle
a
b
c
44712
a
44713