Purenex Wriggle - 2 Pack - Manual

Bottle & Filter Instructions
wriggle
TM
Instructions for Initial Use
1. Unscrew the cap from the bottle.
2. Remove the filter from the cap and set aside.
3. Wash the cap and bottle. The wriggle cap and bottle can be washed by hand or in
the top rack of a dishwasher.
4. Reconnect the filter by pushing and rotating it into the cap. Make sure that the rounded
filter end is toward the cap nozzle. You may hear a soft snap sound as the filter
connects to the cap.
5. Make sure that the filter is properly connected to the cap. When properly connected, the
filter does not fall out of the cap when the cap is lifted.
6. Fill the bottle with water.
7. Thread the cap (with filter) onto the bottle and rotate the cap clockwise to tighten.
Do not over tighten the cap.
8. If the nozzle is not in the down position, push the nozzle down toward the cap. Squeeze
the bottle to test for a proper seal between the cap and the bottle. If you detect air
or water leaking from between the cap and bottle, unscrew the cap and repeat steps
7 and 8 until no air or water leaks upon squeezing.
9. Pull the nozzle up. Over a sink or other appropriate drainage area, hold the bottle
nozzle-side-down and squeeze to release water.
10. Continue to release water until the wriggle is empty. This process rinses out any harmless
residual carbon particles from the filter and makes it ready for use. These residual
carbon particles may initially color the water black. This step is only required the first
time the filter is used.
11. Push the nozzle down, remove the cap, and refill the bottle with water. Tighten the cap
onto the bottle, ensuring that there are no leaks between the cap and bottle.
12. The wriggle is now ready for use! Enjoy cleaner, more healthful water with every
squeeze and sip!
Instructions for Filter Replacement
1. Push the nozzle down and unscrew the cap from the bottle.
2. Pull the filter from the cap and dispose of the filter.
3. Connect the new filter into the cap by pushing and rotating it into the cap. Make sure
that the rounded filter end is toward the cap nozzle. You may hear a soft snap sound
as the filter connects to the cap.
4. Fill the bottle with water.
5. Thread the cap (with filter) onto the bottle and rotate the cap clockwise to tighten.
Do not over tighten the cap.
6. If the nozzle is not in the down position, push the nozzle down toward the cap. Squeeze
the bottle to test for a proper seal between the cap and the bottle. If you detect air
or water leaking from between the cap and bottle, unscrew the cap and repeat steps
5 and 6 until no air or water leaks upon squeezing.
7. Pull the nozzle up. Over a sink or other appropriate drainage area, hold the bottle
nozzle-side-down and squeeze to release water.
8. Continue to release water until the wriggle is empty. This process rinses out any harmless
residual carbon particles from the filter and makes it ready for use. These residual
carbon particles may initially color the water black. This step is only required the first
time the filter is used.
9. Push the nozzle down, remove the cap, and refill the bottle with water. Tighten the cap
onto the bottle, ensuring that there are no leaks between the cap and bottle.
10. The wriggle is now ready for use! Enjoy cleaner, more healthful water with every
squeeze and sip!