Beko DE 2541 F - Manual

*
Values
declared
on
the
product
or
in
the
operating
instruction
booklet
/ programme
chart
and
quick
reference
card
supplied
with
the
product
are
obtained
in
tests
performed
under
controlled
laboratory
conditions
and
these
tests
are
as
defined
in
relevant
standards.
These
figures
may
vary
depending
on
how
soiled
the
dishes
are, the water hardness level and other factors. Temperature changes exceeding 15°C may also effect these figures. **
Reference
programme
for
the
Testing
Institute
and
energy
labelling.
Testing
program:
Eco
50°C
as
compliant
to EN 50242 international norms. ***
Due to continual improvement through research &
design, specifications and design may change without
prior notice.
DE 2541 F Programme Chart and Quick Reference Guide
Before starting, it is essential that you carefully read right through the Installation &
Operation
Instruction
booklet
before
plugging
in
to
the
mains
socket.
Printed in Turkey Part no: 17 2197 01 00-02
Beko
plc,
Beko
House,
Caxton
Way,
Watford,
Hertfordshire,
WD18
8UF
Tel : 01923 654650 Fax : 01923 819653 e-mail: [email protected]
w
w
w
.beko.co.uk
Detergent
compartment
A=25 cm³ /
15 cm³
B=5 cm³
Programme
sequence
Consumption
figures
Water (Litres) Energy (kWh) Duration
(min)
Programme
symbols and temperatures
Programme
selection
14,4 1,30 115
70 °C wash
Cold rinse
50 °C rinse
50°C Prewash
A+B Drying
5 INTENSIVE
70°C
Heavily soiled
dishes
requiring Hot
pre-wash
A+B 10,6 1,15
58
QUICK & CLEAN
60°C
4
Soiled dishes 60 °C wash
Cold rinse Hot rinse
Drying
A+B
13
1,01 140
3 ECONOMY
50°C
50 °C wash
Cold rinse Hot rinse
Drying
Prewash
Most
economic
programme for normally soiled dishes
A
35 °C wash
Cold rinse Hot rinse
End
10,2 0,75
30
2
RAPID
35°C
Lightly soiled
dishes
30 minute programme
-
3,6
-
15
Pre-wash to
rinse and
loosen residue - awaiting full
load - then
select a
Programme 1
PRE-W
ASH
No Heat
End
Prewash
On / Of
f
1 PRE-W
ASH
No Heat
3 ECONOMY
50°C
QUICK & CLEAN
60°C
4
5 INTENSIVE
70°C
End
W
ash
Salt
Start / Stop Rinse
Aid
3
1
2 4
5
2
RAPID 35°C
End
End
End
On/Off indicator light
Start/Stop Button
St
art / S
top
Operating the dishwasher How to cancel the washing programme
Programme Sequence ·
Turn the water tap on. Open the door of the machine.
·
Check that the upper and lower arms can rotate freely.
·
Pour (Put in) the detergent.
·
Close the door of the machine.
·
Push
in
the
on/off
button
and
check
that
the
on/off
indicator
light
comes
on.
·
Check the salt and rinse aid level indicator
lights before you start the machine. If necessary
add salt and rinse aid. ·
Select
the
required
programme
by
referring
to
the
programme
chart.
·
Select the desired programme by turning the selector knob.
·
Press
start
/
stop
button
and
check
that
the
wash
indicator
light
comes
on.
!
Do not open the dishwasher door whilst the
appliance is in operation. However, in case the
door
is
opened
while
the
machine
is
working,
then
a
safety
mechanism
ensures
the
machine
immediately stops. Water may be very hot, so be careful. !
Care
must
be
taken
if
opening
the
door,
as
steam
and
water
will
escape.
·
Press
the
on/off
button
after
the
programme
is
completed.
The
indicator
light
will
go
off.
·
Turn off the water tap, unload the baskets.
To cancel a programme while the machine is operating: ·
Press
and
hold
start/stop
button
for
3
seconds.
The
wash
indicator
light
will
start
flashing.
The machine will drain the water inside the machine for 45 seconds. ·
The programme is cancelled when wash indicator light goes off. Then, you can choose and
start a new programme. !
Depending
on
the
stage
of
the
programme
you
have
cancelled,
there
may
be
detergent
residue or rinse aid inside
the machine and on the load.
Make sure the items
in the dishwasher
are not used before washing properly. To change the programme selection while the machine is operating: ·
Press start/stop button. The wash indicator light will go off.
·
Select the new programme. Press start/stop button. The wash indicator light will be on and
new programme will start. !
The new programme will NOT start
right from the beginning. It will
start from the stage last
carried out by the previous programme selection.
How to change the washing programme
While
the
dishwasher
operates,
"Wash"
indicator
light
will
be
on.
When
the
programme
selected
is
completed,
"Wash"
indicator
light
will
go
off
and
"End"
indicator
light
will
come
on.
Salt
Salt indicator light
Rinse
Aid
Rinse-aid
indicator light On / Off Button
On / Off
Progress
indicator lights
W
ash
End