Salsbury Industries 4460 Victorian Mailboxes - Manual

Victorian Mailboxes – 4460
Surface Mounted Installation Instructions
Made of cast aluminum with a durable powder coat finish and a brass mail flap, 4460 Victorian surface mounted mailboxes will provide years of
maintenance free service.
Mounting the Victorian Mailbox to a Flat Wall
1. The installation fasteners are not provided due to the variation in
wall types to which the mailbox might be mounted. Select fasteners
and anchors appropriate for the type of wall.
2. Mounting access is provided by opening the mail flap and mail
access door.
3. Where possible, it is best to shield the mailbox from direct
weather conditions.
4. Contact your local U.S.P.S. office for the required height of the
mailbox on the wall.
5. For convenience, the mounting holes are key-holes. See
illustration.
6. Holding the mailbox aligned horizontally in the mounting position,
mark on the wall the position of the two mounting holes in the back
wall of the mailbox, behind the “LETTERS” flap.
7. Install the two fasteners, but do not tighten them. Hang the
mailbox loosely on the fasteners, and securely tighten them.
Cleaning
Interior & Painted Exterior – Using a soft cloth or sponge, clean the
interior and painted exterior of the mailbox with liquid soap, detergent
or diluted water-soluble household cleaners. Completely remove
residue of any cleaning products with water and thoroughly dry with a
clean cloth or paper towel.
Brass Mail Flap – The mail flap may be cleaned as indicated above.
DO NOT use abrasive materials on polished brass surfaces.
4460 Victorian Mailbox
SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2008 Salsbury Industries. All rights reserved. (Rev. 02, 7/16/2008)