Salsbury Industries 4874 Deluxe Mailbox Posts - Manual (Page 2)

SALSBURY INDUSTRIES
1010 East 62
nd
Street, Los Angeles, CA 90001-1598
Phone: 1-800-624- 5269 Int’l Phone: 323-846-6700
Fax: 1-800-624- 5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2014 Salsbury Industries. All rights reserved. 3/17/14
Deluxe Bridge Style Mailbox Post
– 4875
Post Assembly Installation Instructions
Thank you for selecting Salsbury’s deluxe bridge style mailbox post. This instruction sheet is for assembling the deluxe bridge style mailbox post. All hardware to
assemble the deluxe bridge style mailbox post is provided.
When you install a curbside or roadside mailbox, make sure that it is easily accessible to the mail carrier. By regulation it should be 41” to 45” from the ground or
street surface up to the inside floor of the mailbox. The door should be set back 6” to 8” back from the front face of the curb or the road edge. However, you should
check with your local postmaster to ensure that the mailbox is installed according to local regulations.
First check to see that all the parts and fasteners in the carton have been located and identified according to the illustration below. Also refer to the illustration below
to position the parts correctly.
1. Attach a right-angle bracket to a post with the long leg on top with two (2) 5/16”-18 x 2” long pan head bolts.
2. Attach a short square-tube arm to the right angle bracket with two (2) 1/4”-20 x 1/2” long flat-head socket screws.
3. Attach a decorative arch to the post and the short square-tube arm with four (4) 5/16”-18 x 1” long hex flange head bolts. Cover with cap plugs.
4. Attach another right-angle bracket to the other side of the post with the long leg on top with two (2) 5/16”-18 x 2” long pan head bolts.
5. Attach the long square-tube arm to the right angle bracket with two (2) 1/4”-20 x 1/2” long flat-head socket screws.
6. Attach another decorative arch to the post and the long square-tube arm with four (4) 5/16”-18 x 1” long hex flange head bolts. Cover with cap plugs.
7. Repeat steps 1 through 6 above for the other the post. This completes the assembly.