Salsbury Industries 1300 Series Cast Aluminum Plaques - Manual

Cast Aluminum Plaques – 1300 Series
Surface & Lawn Mounted Installation Instructions
Thank you for selecting Salsbury Industries’ 1300 series cast aluminum surface and lawn mounted plaques. We are confident that the quality and
construction of the plaque will prove to be a good investment. These instructions are intended to assist you in a typical installation. It is
recommended to have the plaque present before starting the installation.
Installation
SALSBURY INDUSTRIES
1010 East 62 nd Street, Los Angeles, CA 90001-1598
Phone: 1-800-624-5269 Int’l Phone: 323-846-6700
Fax: 1-800-624-5299 Int’l Fax: 323-846-6800
www.mailboxes.com engineering @ mailboxes.com
Installation instructions are provided as general guidelines. It is advised that a professional installer be consulted. Salsbury Industries assumes no product assembly or installation liability.
Copyright © 2010 Salsbury Industries. All rights reserved. (Rev. 01, 2/17/2010)
Surface Mounted Plaques
1. Position plaque on flat surface at desired height and
location and mark required screw holes.
2. Using 3/32” drill bit, drill the required pilot holes.
3. Mount plaque and secure.
Lawn Mounted Plaques
1. Place included stake(s) on the bottom (non-lettered) side of
the plaque. Align the pre-drilled holes.
2. Insert 1/4” screws (provided) from the front (lettered) side
through plaque and stake until secure and tight.
3. Push plaque into soft ground or lawn at desired location
until secure and upright.
Cleaning
Using a soft cloth or sponge, clean the plaque with liquid soap,
detergent, or diluted water-soluble household cleaners. Completely
remove residue of any cleaning products with water and dry with a
clean cloth.
Custom Plaques – Surface and Lawn Mounted
Surface Mounted
Lawn Mounted
includes stake(s)