Spaulding Lighting Cimarron CR1 Mast Arm User Manual

Spaulding Lighting Lighting

Advertising
background image

1. MOUNTING MAST ARM FITTER TO FIXTURE AND TO MAST ARM PIPE

Loosen (2) Screws and swing open Door.

Loosen (1) Reflector Panel Screw and swing open Reflector.

Attach Fixture with Gasket to Mast Arm Fitter with (2) ½” Hex Bolts, Lockwashers and Flatwashers.

Torque ½” Bolts to approx. 42 Ft-Lbs.

Engage (4) 3/8-16 X ¾” Set-screws to the cast Mast Arm Fitter.

Slip Arm Fitter onto Mast Arm and adjust Fixture orientation while tightening the (4) Set-screws.

After Leveling the Fixture attached to the Mast Arm, use holes on each side of Mast Arm Fitter to Field Drill

13/32” dia. hole through the Mast Arm Pipe.

Remove Arm Fitter and Fixture from Mast Arm Pipe and Pull the supply wires from Mast Arm Pipe

through Mast Arm Fitter and into the Fixture.

Slip Mast Arm Fitter with Fixture back onto the Mast Arm Pipe, Install the 4” long Bolt and tighten the

(4) Set-screws to approx 18 Ft-Lbs.

Secure 4” Bolt with Flatwasher, Lockwasher, and Nut (Hardware Included). Torque the Bolt and Nut to

approx. 20 Ft-Lbs.

WARNING: FAILURE TO INSTALL THE LONG BOLT COULD POSSIBLY ALLOW THE FIXTURE TO

ROTATE OR DISENGAGE FROM THE PIPE ARM.

OR

MAINTENANCE

WARNING:

DISCONNECT POWER BEFORE INSTALLATION

AFTER LEVELING FIXTURE THAT
IS ATTACHED TO MAST ARM PIPE,
USE HOLE IN MAST ARM FITTER TO
FIELD DRILL HOLE THROUGH PIPE.

MAST ARM FITTER

CIMARRON FIXTURE

GASKET

FLAT WASHER

1/2" HEX BOLT

LOCKWASHER

2.

WIRING

POWER MUST BE OFF.

(WIRING MUST BE PERFORMED BY A QUALIFIED ELECTRICIAN)

Wire service leads to fixture power leads according to local and National Electric Codes.

This Luminaire is equipped with HID Ballasts capable of 120V-480V input.

Wire connections to be made inside Fixture and Supply Wires to be secured inside Fixture.

For direct wire connections, connect ground wire to green wire, connect black to black and

white to neutral. Supply Voltage must match Ballast Voltage.

Close Reflector and secure with Screw. Close Door and tighten (2) Door Screws.

See Installation Instructions for Cimarron, P/N 268-1300-9901.

MAST ARM PIPE

3/8" SET-SCREWS

4" LONG BOLT

SAVE THESE INSTRUCTIONS

CIMARRON CR1

MAF

INSTALLATION INSTRUCTIONS

DOOR

FLATWASHER, LOCKWASHER, NUT

701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000

www.spaulding-ltg.com

93038631 REV A

Advertising