Stack-On FS Series Electronic Lock User Manual

Stack-On Furniture

Advertising
background image

40249-1206

1 12

3

SAFE TOP

VIEW

1

MODELS WITH OPTIONAL SHELVING

The shelving can be installed by locating the shelf clips to the
desired locations and setting the shelf in place. (Figure 4)

SECURING THE SAFE

If you are going to secure your safe to the floor it will first be necessary to drill
pilot holes through the fire insulation in the floor of the safe. First place the safe
in the desired location. Lift the bottom carpeting up to find the two hole locations
marked on the floor insulation. Drill holes through the insulation using the same
diameter drill as the diameter of the mounting hardware you are using
.
IMPORTANT: The fasteners you use must completely fill the hole you drilled into
the insulation. (Figure 3) You must use the fasteners after you drill the holes.
Failure to do so will void the fire rating.

Use these holes to fasten the safe to the floor. Drill the appropriate diameter and
depth of pilot holes into the floor depending on the type of hardware being used
and the type of floor surface. (Figure 2)

Secure the safe with the fasteners and replace the carpeting.

SELECTING A LOCATION
Your safe should be installed in an isolated, dry
and secure area.

For extra humidity control we recommend the
use of a desiccant. Do not drill holes in the safe
for electrical dehumidifying devices. This will
void the fire rating.

For greater security the safe should be located in
a corner and fastened to the floor. (Figure 1)

The safe should be flat against the wall and floor.
Remove the baseboard if necessary. (Figure 2)

HANDLE ASSEMBLY (Select Models only)

Screw the 3 handle spokes into the hub and hand tighten. These spokes are located in
the front foam packaging.
NOTE: Do not use this handle to move the safe.

Serial # / No de série / # de Serie:

Combination # / Combinaison / # Combinación:

Installation Instructions

FS&E-E

Do not store electronic media, computer disks, audio-visual media or photographic negatives in
this safe. This material will not survive the rated internal temperature of the safe. This material
may be damaged or destroyed.

NOTE: You can store your Key #, Serial # and Combination on Stack-On’s
SECURE web site – www.stack-on.com under Service.
Storing your Key # or Combination will provide instant access to this important
information should you ever lose your keys or your combination.
Only you will have access to this information.

®

WARNING

Tip Over Hazard

A child or adult can tip the safe
and be killed or seriously injured.

Failure to secure the safe as
shown in these instructions can
result in death or serious injury
to children and adults.

Children should not play with or
around the safe at any time.

2

4

IMPORTANT

Record the serial number from the tag on the back of the safe or
from the tag on the front bottom corner of the safe.
Keep keys and combination in a secure place away from children.
Do not store trouble key or this document in the safe.
Do not move this safe using its handle. The handle should
only be used for opening and closing the door of the safe.
Removing the back panel on the door will void the fire rating.

Hardware supplied for mounting the safe to the floor: (2) Lag
screws, (2) washers and (2) plastic anchors

Tools required: 17mm socket wrench, drill, 7/16” drill bit, 3/8”
drill bit, Phillips screwdriver.

Advertising
This manual is related to the following products: