STEMCO Pinion Seal - Manual

Part No. 09-930-0003 Hudson 10-466 12/07
STEMCO PINION SEAL
INSTALLATION INSTRUCTIONS
STEMCO - USA
P. O. Box 1989 • Longview, TX 75606-1989
(903) 758-9981 • 1-800-527-8492 • FAX: 1-800-874-4297
www.stemco.com
STEMCO - Canada
5900 Ambler Drive, Units 4 & 5 • Mississauga, ON L4W 2N3
(905) 206-9922 • 877-232-9111 • FAX: 877-244-4555
Step 1
Remove yoke.
Step 2
Remove old seal.
Step 5
Tighten until the
seal flange bottoms
on the cage -or
installation tool
bottoms on cage
(non-flange seals).
Take care not to
overtighten bolt/nut.
Step 6
Remove burrs and
thoroughly clean yoke.
Lube the seal ID.
Install yoke as shown.
Step 3
Remove all burrs
and thoroughly
clean cage bore.
NOTE: If installing the seal
into a worn cage bore, apply
a thin layer of No. 2 sealant
to the OD of the seal before
installation.
Step 4
Align installation tool with
the seal and spline as
shown. Hand tighten
bolt/nut.
Step 7
Refer to axle
manufacturer for yoke
assembly torque
requirements.
ISO 9001:2000 & ISO/TS 16949
STEMCO is a trademark of STEMCO LP ©2007 STEMCO LP
10-466 PinionSealR1 12/19/07 10:37 AM Page 1