STEMCO Bearing Removal User Manual

Bearing removal and installation, Bearing remov al and inst alla tion, Removal

Advertising
background image

Bearing Removal and Installation

2002

Order Entry 1-800-527-8492

Fax 1-800-874-4297

47

BEARING REMOV

AL AND INST

ALLA

TION

Removal

Step 1

Remove hub/wheel assembly from vehicle in

accordance with recommended practices.

Step 2

Remove inboard and outboard bearing cones

and set aside for inspection.

Step 3

Using a mild steel drift or cup driver, carefully

drive out the bearing cups.

- Caution should be used when driving bearing cups,
as drifts and other tools can damage bearings.

- Drifts can damage hub bearing bores. Be careful
not to score bores while removing cups, especially
when using aluminum hubs.

Inspection

Step 1

Inspect the hub bearing bores and shoulders

for damage. The bores should be smooth and free from
scoring, burrs, indications of cup spinning, or other
forms of damage. Remove any burrs or raised areas
using emery cloth, a file, or other appropriate tool.

Step 2

Measure the bearing cup bore and compare to

manufacturer specifications.

Step 3

Inspect bearing cups and cones for damage.

Bearings should be free from chips, contamination, and
signs of excessive wear or excessive heat. Refer to bear-
ing damage analysis literature for identifying possible
bearing issues.

Step 4

Inspect axle spindle bearing journals for any

signs of damage or excessive wear. Remove any raised
areas or burrs using emery cloth, a file, or other
appropriate tool.

Step 5

Journals should be measured and compared

with manufacturer specifications.

Installation

Step 1

Thoroughly clean bearing cups and cones

prior to installation.

- Do not use compressed air to spin bearing rollers as
injury may result if cage does not retain the rollers.

Step 2

Lightly coat the outside of bearing cups

with oil.

Step 3

Using a cup driver, carefully drive bearing

cups into hub bearing bores. Be sure to drive cup
firmly against cup shoulder in hub.

- If a cup driver is not available, a mild steel drift can
be used to install bearing cups.

- Caution should be used when driving bearing cups,
as drifts and other tools can damage bearings.

- NEVER use a bearing cone to drive a bearing cup.
This can damage the bearings and cause premature
failure.

Step 4

Use a feeler gauge to check for gaps between

cup and shoulder.

Step 5

Inspect the bearing cups to ensure no

damage occurred during installation.

Step 6

Lubricate bearing cones according to

recommended practices and proceed with installation
of wheel assembly.

Advertising
This manual is related to the following products: