Bakers Pride GDCO-E - Manual (Page 9)

9
Figure 3
Item 1
Item 2
Item 3
E3770A
E3771A
3/8”-16 Bolt
STACKING INSTRUCTIONS FOR: BCO-E & GDCO-E CONVECTION OVENS
Remove flue from top oven
and replace with item 1
2
1
3 Attach part # 21818062 with 6
each 8-32 stainless screws
Material: 14 ga
201 Stainless
Remove flue from
bottom oven, and
re-install after top
oven is in place.
1. Attach two item 2 to two item 1 using
item 3, 4 and 5.
2. Attach two item 7 to two item 1 using
item 3, 4 and 5.
3. Using proper lifting equipment
attach item 1 to the corresponding
hole patterns located in the bottom
of the oven with item 6.
1 21796810 Weldment, Oven Leg
2 8633102 Caster, 5” Swivel W/Top Plate
3 8227700 Hex Hd 5/16-18 X ¾ Bolt #5 Zn
4 8509300 Washer, Flat SAE, 5/16
5 8435000 Hex-nut 5/16-18
6 82447-00 Hex Hd. 3/8-16 X .750 #5
7 8633101 Caster, 5" Swivel W/Plate & Brake
With Plate Caster
LEG ASSEMBLY INSTRUCTIONS - MODEL:BCO-E & GDCO-E
1 21796810 Weldment, Oven Leg
2 8633515 Foot Insert, Adjustable
3 8227700 Hex Hd 5/16-18 X 3/4 Bolt #5 Zn
4 8509300 Washer, Flat, SAE, 5/16
5 8435000 Hex-Nut 5/16-18
6 82447-00 Hex Hd. 3/8-16 X .750 #5
1. Attach four item 2 to four item 1 using
item 3, 4 and 5.
2. Using proper lifting equipment attach
item 1 to the corresponding hole
patterns located in the bottom of the
oven with item 6.
Without Plate Caster
22
1
77
6
44 3 55 4
66 5
88 7
22
1
77
6
44 3 55 4
66 5
33 2
Item P/N Description Item P/N Description
Figure 4