Thermalright Shaman - Manual

The Ultimate Cooling Solutions ! www.thermalright.com
Installation Instructions:
Step 1:RAM heatsinks Installation Step 2:Multiple-thread Screw Installation
Step 3:Applying Thermal Paste Step 5:Backplate Installation Step 4:Heatsink Installation
Step 6:Screw Nut Installation Step 8:Installation completed Step 7:Fan Parts Installation
After removing stock cooler and RAM heatsinks, clean the surface of GPU and chipsets thoroughly.
Then install the RAM heatsinks A/B/C accordingly.
Apply the Thermal Paste to the base of the
heatsink and the surface of the GPU evenly.
After installing the Multiple-Thread Screws onto
the heatsink, make it to go through the mounting
holes on the VGA card.
Apply the Anti Vibration strips onto both cutting
edges of the heatsink, then pull both ends of the
2 fan clips and make it to go through the mounting
holes.
Make the Translucent washers to go through the
exposed thread screws again after applying the
backplate,then secure it by tightening the
4 screw nuts.
Turn to the back of the VGA card, and put on
washers on the exposed Multiple thread screws ,
then make the backplate to go through the exposed
thread screws.
Please refer to the supported VGA list in the first
page, and mount the Multiple-Thread Screws into
its dedicated holes.
Attach the TY-140 Fan onto the Heatsink to finish
the installation.