Traditions BP6003 BlankPistol - Manual

1375 Boston Post Road • P.O. Box 776 • Old Saybrook, CT 06475 • TEL: 860-388-4656 • FAX: 860-388-4657
www.traditionsfirearms.com
1/03 - 6003I
1873 S
INGLE
A
CTION
B
LANK
P
ISTOL
M
ODEL
BP6003
L
OADING
, S
HOOTING
& C
ARE
I
NSTRUCTIONS
W
ARNING
This blank pistol is chambered to fire only 209 shotgun primers. This pistol is not to be used with any
loaded ammunition containing any type of projectile nor with any powder activated fastening devices.
Damage to mechanism caused by shooting without 209 primers in the chambers will not be covered under warranty.
T O L OAD
Pull back hammer to the half-cock position to allow the cylinder
to rotate. Open the loading gate located on the right side of the
frame, behind the cylinder. Load a 209 shotgun primer into each
of the chambers. Close the loading gate.
T
O
S
HOOT
This blank pistol will only fire in single action which means
when the hammer is pulled back to the full-cock position.
T O R EMOVE C ARTRIDGES
Place the hammer into the half-cock position. Slide the ejector
rod lever back until the 209 primer is pushed out of the chamber.
You will need to align the chamber hole with the ejector rod to
slide it all the way back in order to push the 209 primer out.
C ARE OF G UN
For many years of dependable service, the gun must be cleaned and oiled periodically and always after each use. Remove
powder and dust traces from gun and cylinder chambers and place a drop of oil on all moveable parts. Apply the same
oil to a soft cloth and wipe outside of gun for protection against rust.
W ARRANTY
One (1) year limited warranty. You will need to retain an original purchase receipt to validate your warranty.
W A R N I N G
■ A
LWAYS
W
EAR
S
AFETY
G
LASSES AND
H
EARING
P
ROTECTION
■ H ANDLE T HIS B LANK R EVOLVER AS
Y OU W OULD A NY F IREARM
■ K
EEP
O
UT OF
R
EACH OF
C
HILDREN
■ N EVER A IM A T A P ERSON O R A NIMAL
P
ARTS
L
IST
1. Extractor tube
2. Extractor screw
3. Cylinder rod
4. Cylinder
5. Extractor rod
6. Extractor spring
7. Firing pin nut
8. Firing pin spring
9. Firing pin
10. Trigger screw
11. Hammer screw
12. Left grip
13. Grip screw
14. Cylinder rod spring
15. Cylinder rod spring screw
16. Frame
17. Cylinder stop
18. Trigger spring
19. Trigger spring screw
20. Trigger
21. Frame screw
22. Backstrap
23. Hammer spring
24. Cylinder rod screw nut
25. Loading door
26. Elevator
27. Hammer
28. Pin
29. Spring
30. Elevator spring
31. Right grip
32. Nut