TruXedo Deuce 2 GM With Track System - Manual

Aftermarket or factory side
rail protector cap
Place clamp at or beyond 3”
from either side of the center
post.
P/N 1117777 Rev A
GM W/tracks Deuce 2 InstaLLatIOn sPecIaL InstructIOns
by truxedo, Inc.
P.O. Box 1078, 2209 Kellen Gross Dr., Yankton, SD 57078
Phone: 877- 878-9336 • Fax: (605) 664-9304 www.truxedo.com
cautIOn
!
Place clamp at
or beyond 16”
from the tailgate
nOtIce
NOTE: We recommend additional help to hold rail in
position while installing clamps. A socket extension
is recommended for tightening clamps.
Tighten clamp assemblies securely on side rails
before driving vehicle.
cautIOn
!
1. 1703865 MALE CLAMP
2. 1703864 FEMALE CLAMP
3. 1703487 CAP SCREW 5/16” X 1 1/2”
4. 1700428 FLAT WASHER 5/16”
Item Part # Description
1
Center
support post
2
DETAIL B:
Shim
Incorrect clamping can cause damage to the vehicle. Clamp
ONLY where TWO layers of sheet metal are present. Do not
over tighten clamps.
1 Correct Clamping locations: Place clamps in the locations shown below. See step two for positioning the side rails correctly.
With side rail held in place, insert clamp horizontally between the cargo rail and bottom of bed rail. Using a socket with
extension, tighten the clamps securely. If your truck has factory or aftermarket side rail protectors see detail A & B below.
3”
16”
Place plastic shims between the
side rail protector and the trucks
side rail. The shim must be located
at the same location that a clamp
will be used.
DETAIL A:
3
4
Detail showing shim correctly posi-
tioned between side rail protector
and the trucks side rail.