TruXedo Nissan Titan 2005-2009 - Manual

Next install the underbody Rails. Fold back hinged
portion of side rails, and stand inside pickup bed to
install underbody rails.
1. 1703482 MALE CLAMP
2. 1703481 FEMALE CLAMP
3. 1700369 CAP SCREW 3/8” X 1 3/4”
4. 1700429 FLAT WASHER 3/8”
5. 1703331 Bulkhead weather seal
Item Part # Description
Tighten clamp assemblies securely
on side rails before driving vehicle.
P/N 1117209 Rev B
2004 NISSAN TITAN
by TruXedo, Inc.
P.O. Box 1078, 2209 Kellen Gross Dr., Yankton, SD 57078
Phone : 877- 878-9336 • Fax: (605) 664-9304 www.truxedo.com
CAUTION
!
These instructions replace steps 1, 3 and 4 in the Deuce owners manual.
NOTE: If your Nissan Titan pickup does not have utility tracks, then
install the Truxedo side rails as shown in your Truxedo Lo Pro Deuce
Owners Manual.
D-Seal
Tailgate
Side Rail
Install Side Rails: With tailgate closed, align side rails
flush with pickup bed rails and level with each other.
Lightly compress D-seal against tailgate. Clamp side
rails to bed rails, placing two clamps on fixed portion of
rails near ends of rails. Tighten securely. See step two
in Deuce manual for further clamping information.
1 Bed Rail
2
Fold Back
Underbody Rails
Install Underbody Rails: Position underbody rails
flush with Truxedo ® Deuce side rails as shown. Clamp
underbody rails to pickup bed.
3
Align weather seal
arc slightly higher
than pickup rail.
Flush
To finish installation, continue with step 5 in the Deuce manual
R R
Clamp half 1703481 is
installed in the Utility Track.
Utility track
Clamp arrangement if truck does
not have Utility Tracks.