USG SHEETROCK Corner Bead DUR-A-BEAD - Manual

Application Use drywall nail or staples spaced 9 Љ o.c. in both flanges and placed opposite. Fasten to framing through board.
May use “clinch-on” tool to attach. Use correct-size tool for flange width. Finish corner with three coats of joint
compound; use only two coats with S
HEETROCK ® Brand lightweight compounds.
S
HEETROCK ™ Brand
Corner Bead
Application Tips
D
UR
-A-B
EAD ™
Manufactured by
United States Gypsum Company
125 South Franklin Street
Chicago, IL 60606 800 USG.4YOU (874-4968)
www.usg.com J1765/2-04
©2004, United States Gypsum Company
Printed in U.S.A.
Trademarks
The following trademarks used
herein are owned by United
States Gypsum Company or a
related company: D
UR -A-B EAD ,
S HEETROCK .
Note
Products described here may
not be available in all geographic
markets. Consult your U.S.
Gypsum Company sales office
or representative for information.
Notice
We shall not be liable for inci-
dental or consequential dam-
ages, directly or indirectly sus-
tained, nor for any loss caused
by application of these goods
not in accordance with current
printed instructions or for other
than their intended use. Our lia-
bility is expressly limited to
replacement of defective goods.
Any claim shall be deemed
waived unless made in writing
to us within thirty (30) days from
the date it was or reasonably
should have been discovered. SAFETY FIRST!
Follow good safety practices.
Read material safety data
sheets and related literature on
products before specification
and/or installation.