WarmlyYours TempZone Shower Mat (Bench & Floor) - Manual

Installation Support • No Nonsense™ Warranty • (800) 875-5285 • www.WarmlyYours.com
TempZone™ Shower Mat (Bench & Floor)
InstallatIon InstructIons
stEP 1
Once the mortar bed has set, dry fit the TempZone™
Shower Mat to verify its dimensions and ensure it fits
the contours of the shower area.
Conduct insulation & resistance tests. Record
readings on the warranty card found inside the
TempZone™ Installation instructions.
step 2
Attach the mat to the subfloor using hot glue.
Prepare the latex-modified thinset. Using a flat
trowel, spread a coat of thinset over the installed
mat.
For best results, we recommend a 1” maximum
distance between the heating cable and the top of
the tile. (see Figure 6)
Please ensure the slope of the mortar bed is
maintained to direct water toward the shower drain.
Allow the thinset mortar to set. Conduct resistance
tests and record readings on warranty cards.
step 3
Using a hot glue gun, secure the cold lead to
the mortar bed and over the shower curb. In
order to minimize tension on the cold lead, use
an “S” formation to bring the cold lead over the
shower curb. Do not allow the tip of the hot glue
gun to touch the cold lead as it may damage the
TempZone™ Shower Mat.
Direct the supply lead to the thermostat box or
junction box.
stEP 1
stEP 2
stEP 3