Brother MFC-7225N - Manual (Page 43)

Troubleshooting
8 - 3
8
(5) Make the following selection. Make sure that your print/scan server appears. If it is visible, then the
connection is good. Otherwise, go to Step 5.
5
If you have tried 1 to 4 above and it does not work, then reset the print/scan server back to the default
factory settings and try from the initial setup again. For information how to reset to the default factory
settings, see Restoring the network settings to factory default on page 3-8.
6
Check if a personal firewall such as ICF (Internet Connecting Firewall) for Windows XP is running on
your computer. If it is running, temporarily turn it off and try again.
Note
If none of the above steps are successful, there is almost certainly a hardware or network problem!
Printing problems
Print job is not printed
Make sure the status and configuration of the print/scan server. Check following:
1
Make sure that the machine is powered on, is on-line and ready to print.
2
Print the Network Configuration Page of the machine and check if the settings such as IP address
settings are correct for your network. The problem may be the result of mismatched or duplicate IP
address. Verify that the IP address is correctly loaded into the print/scan server. And make sure that no
other nodes on the network have this IP address.