Wolo 860 AIR RAGE User Manual

Model 860 air rage ™ air tank & compressor, Installation instructions for, Fig. 1 fig. 2

Advertising
background image

Your purchase of an AIR RAGE Air Tank & Compressor is a perfect choice to power your high-pressure air

horns, tools and accessories. The Wolo name, with more than thirty years of experience, is your guarantee of

a superior horn product. If you need help installing this product, our technicians are available to answer your

questions, Monday through Friday from 9 AM to 4 PM EST by calling 1-888-550-HORN (4676).

IMPORTANT: The compressor comes pre-mounted

to the air storage tank. The installer has the option to

separate the compressor from the tank and mount it

independently.

INDEPENDENT COMPRESSOR / TANK MOUNTING

(Fig. 1):

1. If the method of mounting the compressor is to be

independent of the tank, remove the four screws that

secure the compressor to the tank, then disconnect

the braided hose from the tank. You will now be able

to separate the compressor from the tank.

COMPRESSOR and TANK INSTALLATION (Fig. 2):

IMPORTANT! When selecting a mounting location for

the compressor, make sure that the compressor’s

braided hose will be close enough to the tank’s inlet

connection.

COMPRESSOR INSTALLATION (Fig. 2A):

2. Locate a convenient location to mount the

compressor that will be dry. If the location

is the engine compartment make sure

the compressor is safe from the heat of

the exhaust manifold and try to mount

compressor as far to the front of vehicle as

possible to provide optimum airflow around

compressor. IMPORTANT! Do not mount

on a plastic fender well, or on flexible

material.

3. Using the compressor’s mounting base as

a template, mark the hole locations and

drill to size, use a 3/16” drill bit. Secure the

compressor to the mounting surface using

the hardware provided. (Fig. 2A)

TANK INSTALLATION (Fig. 2B):

4. The mounting location for the tank should

be easily reachable so that the tank

can be periodically serviced, draining

condensation, water from the petcock

located on the bottom of the tank.

5. Use the tank’s mounting bracket as a

template, mark the hole locations and drill

to size 15/32”. Secure tank with hardware

provided.

Installation Instructions for

Model 860 AIR RAGE AIR TANK & COMPRESSOR

Fig. 1

Fig. 2

Remove

the four

screws

Disconnect

the braided

hose

Make sure

that the

locations

of the

compressor

and the tank

will be close

enough to

allow the

braided hose

to connect to

tank’s inlet

Tank’s

outlet

connection

Fig. 2B

Use the tank’s mounting base

as a template to mark the

15/32” holes for drilling

Fig. 2A

Use the compressor’s mounting

base as a template to mark the

3/16” holes for drilling

Tank’s inlet

connection

Advertising