X-1 (H2O Audio) iV6-1A3 - Manual (Page 3)

1. Installing and Replacing Case Rails
4.
Repeat steps 1 - 3 to replace the other black rail.
3.
Replace the black rail that was removed, with a thin grey
rail provided in this bag. Use the screws that were removed
in Step 1 to secure the thin grey to the case.
2.
Once all the screws are removed, gently lift the black rail
out of the case. Do not leave any screws in the case as
they may interfere when closing the case.
1.
Use the small Phillips Screwdriver in a counterclockwise
direction to remove all three ( 3 ) screws from the black rail.
CAUTION: For the iPod classic 160GB to fit into the case
you must replace the thick black rails that come installed in
the housing with thin grey rails which are included in this
bag.
iV6 - 52 20071012
NOTE: Be very careful, do not damage the T - Seal with the screwdriver.
*If you are unsure which rails you need or if you need rails please contact H2O Audio*
( Additional Screws are provided with rails. )
»
continued on back