X-1 (H2O Audio) iV6-1A3 - Manual (Page 5)

7. Installing the iPod into the Case
Installing the iPod
Removing the iPod
1.
Align the audio port with the
stereo jack in the case.
1.
Slide the player
off of the stereo
jack. Player will
slide up the
ramps at the
bottom of the
case.
2.
Gently snap the player into the audio
jack.Verify that the player is completely
plugged into the audio jack.
2.
Rotate the case
to drop the player into
your hand.
NOTE: Do not disturb the T-Seal during removal of the player. If the T-Seal is moved, Please use the
case lid to completely seat the T-Seal.
IMPORTANT: The iV6 Waterproof Case is configurable for two different size iPod classic’s. Follow the
instructions on the rail replacement card to configure it properly. Contact Customer Support with any
questions.
6. The T-Seal
This product uses a high grade silicone “T-Seal”.
DO NOT USE SILICONE GREASE as this will damage the seal.
The black T-Seal between the base and the lid of the case is what keeps your
iPod classic safe and dry. It is very important that the seal always be fully
seated, and free of sand, dirt, hair, lint or other debris. Visually inspect the
T-Seal and Contact Surface prior to each use. If you see scratches, or other
imperfections, do not use the case. Wipe clean as necessary using a soft lint
free cloth. If you have questions, contact H2O Audio Customer Support.
Contact Surface
T-Seal
To ensure the T-Seal is fully seated in the base of the case, firmly squeeze
both sides (the base and lid) of the case together after each insertion of the
player. Always check to make sure the latch is closed and locked prior to use.
Squeeze both sides of
the case together
5. Unlock / Locking the Case
Unlocking your case Locking your case
3.
Verify the lid and latch are closed
and the button is positioned on
the icon prior to entering the
water.
3
2.
Snap the latch downwards
to lock in place.
2
1.
Lift the top latch over the lid
hooks. Compress the lid to
the base if the latch can does
not clear the lid hooks.
1
3.
Lift the top latch over the lid
hooks. Compress the lid to the
base if the latch does not clear
the lid hooks.
3
2.
While holding the latch button
towards the unlock icon,
push up on the side of the latch.
2
1.
Slide latch button towards
the unlock icon.
1
3. Introduction
4. Leak Test
The H2O Audio waterproof case lets you to listen to digital audio during active
watersports. It houses the Apple iPod classic digital media player.
Case: The case features the LatchTight TM Locking System which keeps the unit
waterproof during operation. The H2O Audio case allows for functional control
of the player while in the water with the Commander
TM Scroll Wheel.
NOTE: The iPod classic is NOT waterproof without the H2O Audio Case and
Waterproof Headphones and is NOT covered under the product warranty.
Any attempt to use the case with an audio player other than the Apple iPod
classic will void the Warranty.
HEADPHONES: The case is only waterproof when combined with H2O Audio
Waterproof Headphones (sold separately). Use of other headphones with a
3.5mm stereo connector will result in a water resistant case, and should not
be submerged.
Before utilizing the system for the first time, it is highly recommended to
perform a 'Leak Test'. Follow the instructions below.
1. Open the case (Section 5), and verify the T-Seal is clean and free of debris.
2. Close the case (Section 7) and attach H2O Audio Waterproof Headphones.
3. Immerse the case, (without the iPod classic) in water and soak for 30 min.
4. Manipulate the Control Pad during submersion.
5. Remove from the water, dry the exterior. Visually inspect the case for any sign of leaks
before opening.
6. Open the case upside down to prevent water from dropping into the case during
opening.
DO NOT INSTALL THE iPod classic
INSIDE THE CASE FOR THE LEAK TEST
2. Case Features
IMPORTANT: The iV6 Waterproof Case is configurable for two different size iPod classic’s. Follow the
instructions on the rail replacement card to configure it properly. Contact Customer Support with any
questions.
Display Window
SealTight Connector
TM
Commander Scroll
Wheel Control
TM
LatchTight Locking
System
TM
Before using this system, please be sure to read, understand, and follow the instruction of this manual.
Armor Series
h2oaudio.com
iV6 Waterproof Case
for the iPod
® classic
iV6 - 70 20071012