Agio International Full Cushion Swivel Chair - Manual

PARTS LIST DESCRIPTION
1
1
PARTS LIST DESCRIPTION QTY./PCS QTY./PCS
CHAIR FRAME
SWIVEL BASE
NUT
4
HEX WRENCH-1 1
PVC BOLT COVER
WASHER
1
4
4
BOLT 4
METAL PLATE 2
SPRING WASHER 4
HEX WRENCH-2
Page 2
SEAT DESIGNS MAY
VARY BUT THE ASSEMBLY
IS THE SAME
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
NOTE: MAKE SURE ARROWS
FROM BOTH THE “U” BAR
AND SWIVEL PLATE ARE
POINTING IN THE SAME
DIRECTION!
MODEL # 50-19911
"U" BAR
SWIVEL BASE
METAL PLATE
WASHERS
SWIVEL PLATE
SPRING WASHERS
NUTS
Step 1: Identify all parts packed in carton against the parts list. Remove
all protective materials. Place parts on a non-abrasive surface
to avoid scratching. If you are missing any parts or are unsure
how to proceed with assembly, please call our Customer Service
Center immediately at 1-800-416-3511. Do not attempt to
assemble the chair if any parts are damaged or missing.
IMPORTANT NOTE: WE RECOMMEND TWO PEOPLE WORK
TOGETHER TO ASSEMBLE THE CHAIR.
Step 2: Position the swivel base on a flat, solid surface. Make sure the
swivel plate is positioned all the way into the base. It may have
vibrated out during shipment.
Step 3: Note the arrows on both the swivel plate and the “U” bar portion
of the chair frame. Position the chair frame onto the swivel plate
so that the two pairs of holes in the “U” bar are exactly aligned
with the two pairs of holes in the swivel plate and the arrows on
both the “U” bar and swivel plate are pointing in the same direction.
Proper positioning of the chair frame on the swivel plate/swivel
base, and proper alignment of the holes in the “U” bar with the
holes in the swivel plate are critical to the safe, well balanced
swiveling motion of the chair.
Step 4: Carefully examine the diagram. Attach a metal plate to two (2) bolts
and guide the bolts through the top of one set of holes in the "U" bar
(located at the bottom of the chair frame) and into the pair of holes in
the swivel plate. From beneath the swivel plate, add a washer, then a
spring washer and a nut to the end each bolt. Hand tighten 3-4
revolutions only. Repeat procedure for pair of holes on the opposite
side. Again, hand tighten nuts 3-4 revolutions only. Do not tighten
nuts completely.
Step 5:At this time tighten all nuts and bolts with the hex wrenches provided.
Do not over tighten. Over tightening may strip the bolts and cause
damage to the swivel plate, making the chair unsafe.
Step 6:Your chair should now be ready for use. If you do not feel that your
chair is swiveling properly, double-check your assembly procedure,
especially step 3. If you have any questions, please call our
Customer Service Center at 1-800-416-3511.
CHAIR FRAME