Rockwell Automation 22-COMM PowerFlex 4-Class DSI (Drive Serial Interface) Network Communication Adapter User Manual
Page 3
3
Figure 2 Connecting DSI Ports with Internal Interface Cable
Item Description
➊
DSI Connector
➋
15.24 cm (6 in.) Internal Interface cable
➌
Network cable
PowerFlex 400 Class Frame D and Higher
C. With the adapter board right side up, remove its mounting screw from
the lower left hole. Save the screw for mounting in step F.
D. Connect the Internal Interface cable to the DSI port on the drive (see
E. With the adapter board oriented bottom side up, route the Internal
Interface cable under the adapter, and then to the mating DSI connector
on the adapter.
F. Install the adapter, bottom side up, to the right side of the display board
by snapping it into place. Then insert the adapter mounting screw into
the lower left hole on the board.
Important: Tighten the mounting screw in the adapter’s lower left hole
to ground the adapter to the drive.
➋
➊
➌
(22-COMM-E EtherNet/IP
Adapter shown as example)
PowerFlex 40 Drive
(Frame C shown as
example with cover removed)
Back of Required
Special Drive Cover