Rockwell Automation 7000 DPI Wireless Interface Module - Manual (Page 48)

3-26 Configuring the WIM
To reset a PIN number when misplaced or forgotten
If you misplaced or forgot the assigned PIN number, you will not be able
to connect to the WIM using drive software.
• DPI Drive – To reset the PIN number, you will first need to access
the WIM through a different DPI peripheral (for example, a
20-HIM). Using that peripheral, select Parameter 03 - [Security
Mode] and set it to “0” (PIN Not Required). Then select Parameter
04 - [Security PIN] to view the stored PIN number.
• SCANport Drive – Since a SCANport drive does not support
peripheral routing, you cannot access the WIM parameters using a
legacy HIM (for example, a 1201-H*). To reset the PIN number, you
will need to disconnect the WIM and reconnect it to a DPI drive.
This enables access to the WIM parameters to reset or disable the
PIN number. For additional assistance, contact Drives Technical
Support at the numbers listed on
Page P-2 .
Changes to some WIM parameters require that you reset the WIM before
the new settings take effect. You can reset the WIM by cycling power to
the drive or by using Parameter 05 - [Reset Module].
Set Parameter 05 - [Reset Module] to Reset Module.
After you enter 1 = Reset Module, the WIM will be immediately reset.
Important: This will break the wireless connection, so you will need to
re-establish the connection.
When you enter 2 = Set Defaults, the WIM will set all WIM parameters
to their factory-default settings. After performing a Set Defaults, enter
1 = Reset Module so that the new values take effect. The value of this
parameter will be restored to 0 = Ready after performing the reset or
setting the defaults.
Resetting the WIM
Value Description
0
Ready (Default)
1 Reset Module
2 Set Defaults