Rockwell Automation 1500SM BULL 1500-ISOLATOR ADJ MAINT - Manual

Refer to the contactor publication provided under this tab for an illustration and
general instructions on the interlock mechanism.
The two drawings provided we to be used by the customer to identify major
components referenced in the following instructions. They may or may not
relate directly to the assemblies supplied on the customer’s order.
Electrically Conductive Part Lubrication:
(Using Aeroshell 7 or equivalent NO-OX-ID “a special” Dearborn Chemical)
• lubricate switch plates (Item 2 on 80098-595)
• lubricate grounding pins located on ground bar (Item 1 on 80098-595)
• lubricate back terminals (Item 3 on 80098-595)
Mechanical Part and Linkage Lubrication:
(Using Mmolykote Dow Corning 55m silicon grease)
• lubricate isolator shaft support molding (both ends) to allow smooth
rotation of the shaft (Item 7 on 80098-595)
• lubricate isolator shutter lever assembly pin which controls moveable
shutter (Item 17 on 80098-595)
Isolation Switch Shutter Lubrication:
(Using Chesterton Dry Lube Spray NR677)
• spray between the two shutter surfaces of the moveable and stationary
shutter (Items 5 and 6 on 80098-595)
Bulletin 1500 Isolator Handle and
Isolator AssemblyAdjustment and
Maintainance
Instructions
Lubrication