Rockwell Automation 1560D SMC OEM Products - Interface Board (Instruction Sheet) - Manual

SMC OEM Products
Interface Board - Instruction Sheet
Handling ATTENTION: Do not bend the gold post connectors on the
Interface Board when handling it. Damage to the post
connectors may result in loss of communication signals from
the MV Dialog Plus to other components.
• Carefully unpack the item and inspect it for damage that may have
occurred during shipping. Immediately report any damage to the
claims office of the carrier. Rockwell Automation will render reason-
able assistance in resolving a damage claim.
ATTENTION: Electrical components may be damaged or
destroyed by electrostatic charges that build up in personell
during normal activities. To avoid damage to the equipment,
observe the following precautions.
• To guard against electrostatic damage (ESD) to equipment the follow-
ing precautions should be observed when handling electrostatic
sensitive devices.
1) Use a grounding wrist strap to minimize the build up of static charge
on personnel.
2) Handle the module by the edges and avoid touching components or
printed circuit paths.
3) Store devices with sensitive components in the conductive packaging
that the module is shipped in.
• These precautions are the minimum requirements for guarding against
ESD. For more information refer to Guarding Against Electrostatic
Damage - Publication ICCG-4.3.
Identification Verify the catalog and part numbers of the interface board.
Figure 1
Interface Board Options and Catalog Numbers
System Voltage Control Circuit Voltage and Frequency Catalog Number Part Number
800V to 4800V 110/120VAC, 50/60 H 1503D-INTGD 80187-131-51
220/240VAC, 50/60 H 1503D-INTGE 80187-131-53
4801V to 6900V 110/120VAC, 50/60 H 1503D-INTKD 80187-131-52
220/240VAC, 50/60 H 1503D-INTKE 80187-131-54
Note: The following connectors are supplied with the Interface Board: 80174-025-02, 80174-025-05, 80174-025-10