Rockwell Automation 1336 PLUS User Manual

Lifting instructions for 1336 plus and force, D” frame drives, Installation instructions

Advertising
background image

Lifting Instructions for 1336 PLUS and
FORCE

“D” Frame Drives

This publication will guide you through the steps needed to properly
lift and mount the following drives:

1336 PLUS – 30-112 kW (40-150 HP)

1336 FORCE – 30-112 kW (40-150 HP)

!

ATTENTION: To guard against possible personal
injury or equipment damage . . .

• Do Not allow any part of the drive or lifting mecha-

nism to make contact with electrically charged con-
ductors or components.

• At no time should a person or their limbs be directly

underneath the items being lifted.

• Do not subject the load to high rates of acceleration

or deceleration.

• Inspect all lifting hardware for proper attachment

before lifting drive unit.

The following items will be required to properly lift the drive –
mounting method chosen will determine quantities needed.

Item

Load Rating

Quantity

McMaster-Carr P/N

Wire Rope Sling

462.7 kg (1020 lb.)

2 or 4

3550T113

Adjustable Spreader Bar

1134 kg (2500 lb.)

1

3977T11

Anchor Shackle

1361 kg (3000 lb.)

4 or 6

3663T51

“S” Hook

227 kg (500 lb.)

2 or 4

3631T71

Perform the following steps to vertically mount the drive.

1. Determine the center of gravity for the drive. The hoist hook must

be located directly above the center of gravity to assure that the
drive hangs properly. For example, the center of gravity for a
380-480V, 93 kW (125 HP), 1336 PLUS stand-alone open chassis
drive is about 50.8 mm (2 in.) to the left of center.

Installation Instructions

Required Lifting Components

Vertical Drive Mounting

Advertising