Rockwell Automation 1336F PLUS II Custom Firmware Inst. - EN935 - Manual

Instructions
Custom Software EN935 differs from the standard 2.004 firmware in
the following way:
• MOP frequency source is programmed to reset to zero following a
stop.
!
ATTENTION: The Custom Software supplied is designed
for a specific application and differs from the standard 1336
PLUS II product offering. It must be installed and run only
under this custom application. Attempting to run this
Custom Software under any other type of application or
condition, could result in unpredictable and/or hazardous
conditions.
!
ATTENTION: This drive contains ESD (Electrostatic
Discharge) sensitive parts and assemblies. Static control
precautions are required when installing, testing, servicing
or repairing this assembly. Component damage may result
if ESD control procedures are not followed. If you are not
familiar with static control procedures, reference A-B
publication 8000-4.5.2, “Guarding Against Electrostatic
Damage” or any other applicable ESD protection handbook.
1336 PLUS II Custom Firmware
EN935 – MOP Reset on Stop
Publication 1336 PLUSII-5.935 – January, 2000 P/N 194092 (02)
Supersedes July, 1999 Copyright 2000 Rockwell International Corporation. All rights reserved. Printed in USA.