Rockwell Automation 1606-XLE480FP Power Supply Reference Manual - Manual

Reference Manual
Bulletin 1606 Switched Mode Power Supplies
Catalog Number: 1606-XLE480FP
Index
e g a P e g a P
1. Intended Use .......................................................3
2. Installation Requirements...................................3
3. AC-Input...............................................................4
4. DC-Input...............................................................5
5. Input Inrush Current ...........................................5
6. Output .................................................................6
7. Hold-up Time.......................................................8
8. DC-OK Relay Contact ..........................................8
9. Efficiency and Power Losses................................9
10. Lifetime Expectancy and MTBF.........................10
11. Functional Diagram...........................................10
12. Terminals and Wiring........................................11
13. Front Side and User Elements...........................12
14. EMC....................................................................13
15. Environment ......................................................14
16. Protection Features ...........................................15
17. Safety Features ..................................................15
18. Dielectric Strength ............................................16
19. Certifications......................................................16
20. Physical Dimensions and Weight ..................... 17
21. Accessories ........................................................ 18
21.1. 1606-XLC Wall Mounting Bracket......... ...18
22. Application Notes............................................. 19
22.1. Peak Current Capability ...........................19
22.2. Back-feeding Loads ..................................19
22.3. External Input Protection .........................20
22.4. Output Circuit Breakers ............................20
22.5. Parallel Use to Increase Output Power ....21
22.6. Parallel Use for Redundancy ....................21
22.7. Series Operation .......................................22
22.8. Inductive and Capacitive Loads ................22
22.9. Charging Batteries ....................................23
22.10. Operation on Two Phases ........................23
22.11. Use in a Tightly Sealed Enclosure ............23
22.12. Mounting Orientations ............................24
• PE and symbol—PE is the abbreviation for Protective Earth and has the same meaning as the symbol .
• Earth, Ground—This document uses the term “earth” which is the same as the U.S. term “ground”.
• T.b.d.—To be defined, value or description will follow later.
• 3AC 400V—A figure displayed with the AC or DC before the value represents a nominal voltage with standard tolerances (usually ±15%)
included. E.g.: DC 12V describes a 12V battery whether it is charged (13.7V) or discharged (10V).
• 230Vac—Afigure with the unit (Vac) at the end is a momentary figure without any additional tolerance included.
• 50Hz vs. 60Hz—Unless otherwise stated, AC 230V parameters are valid at 50Hz mains frequency.
• may—A key word indicating flexibility of choice with no implied preference.
• shall—A key word indicating a mandatory requirement.
• should—A key word indicating flexibility of choice with a strongly preferred implementation.
Terminology and Abbreviations