Rockwell Automation 1395/1396 Power Supply Kit - Manual

!
1395/1396 Power Supply Kit
Instructions
Description The Power Supply Kit provides the necessary components and instructions needed
to replace the 1395/1396 power supply, should replacement become necessary.
The following components are included in the kit:
- (1) Power Supply Board
- (1) Short Cable Assembly (for 3.6 through 345A Drives)
- (1) Long Cable Assembly (for 346 through 980A Drives)
- (3) Wire Labels
- (1) Connector, 3 Pin, PCB Plug-in
Replacement Procedure
ATTENTION: To avoid an electrical shock hazard, assure that all
power to the drive has been removed prior to performing the following
procedure.
- 1. Assure that all power to the drive is removed.
- 2. Locate the existing Power Supply Board.
3.6 through 345A Drives
Loosen the two (2) captive screws securing the swing-down panel.
Carefully swing the panel down exposing the board. See Figure 1.
346 through 980A Drives
Refer to Figure 1 for location of board.
Figure 1
Power Supply Board Locations
3.6 - 345A Drives (typical, shown for location only) 346 - 980A Drives (typical, shown for location only)
Power Supply
Board