Rockwell Automation 1606-XLE240F-3 Power Supply Reference Manual User Manual

Bulletin 1606 switched mode power supplies, Reference manual, Terminology and abbreviations

Advertising
background image

Reference Manual

Bulletin 1606 Switched Mode Power Supplies

Catalog Number: 1606-XLE240F-3

Index

e

g

a

P

e

g

a

P

1.

Intended Use .......................................................3

2.

Installation Requirements...................................3

3.

AC-Input...............................................................4

4.

DC-Input...............................................................5

5.

Input Inrush Current ...........................................5

6.

Output .................................................................6

7.

Hold-up Time.......................................................7

8.

Efficiency and Power Losses................................8

9.

Functional Diagram.............................................9

10. Front Side and User Elements.............................9
11. Terminals and Wiring........................................10
12. Reliability ...........................................................10
13. EMC ....................................................................11
14. Environment ......................................................12
15. Protection Features ...........................................13
16. Safety Features ..................................................13
17. Dielectric Strength ............................................13
18. Certifications .....................................................14

19. Environmental Compliance ............................. 14
20. Physical Dimensions and Weight ..................... 15
21. Accessories ........................................................ 16
22. Application Notes ............................................. 17

22.1. Peak Current Capability ...........................17
22.2. Back-feeding Loads ..................................17
22.3. Charging Batteries

...............................18

22.4. Output Circuit Breakers ............................18
22.5. External Input Protection .........................19
22.6. Using only 2 Legs of a 3-Phase System ....19
22.7. Inductive and Capacitive Loads ................20
22.8. Parallel Use to Increase Output Power ....20
22.9. Parallel Use for Redundancy ....................20
22.10. Daisy Chaining of Outputs .......................21
22.11. Series Operation .......................................21
22.12. Use in a Tightly Sealed Enclosure ............21
22.13. Mounting Orientations ............................22

• PE and

symbol—PE is the abbreviation for Protective Earth and has the same meaning as the symbol

.

• Earth, Ground—This document uses the term “earth” which is the same as the U.S. term “ground”.

• T.b.d.—To be defined, value or description will follow later.

• AC 230V—A figure displayed with the AC or DC before the value represents a nominal voltage with standard tolerances (usually ±15%)

included. E.g.: DC 12V describes a 12V battery disregarding whether it is full (13.7V) or flat (10V)

• 230Vac—A figure with the unit (Vac) at the end is a momentary figure without any additional tolerances included.

• 50Hz vs. 60Hz—As long as not otherwise stated, AC100V and AC230V parameters are valid at 50Hz and AC120V parameters are valid at 60Hz

mains frequency.

• may—A key word indicating flexibility of choice with no implied preference.

• shall—A key word indicating a mandatory requirement.

• should—A key word indicating flexibility of choice with a strongly preferred implementation.

Terminology and Abbreviations

Advertising
Table of contents