Rockwell Automation 1734-IE4S POINT Guard I/O Safety Modules User Manual User Manual
Point guard i/o safety modules
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- POINT Guard I/O Safety Modules, 1734-UM013J-EN-P
- Important User Information
- Summary of Changes
- Table of Contents
- Preface
- 1 - POINT Guard I/O Overview
- 2 - Safety Inputs, Safety Outputs, and Safety Data
- 3 - Guidelines for Placing Power Supplies and Modules in a System
- 4 - Install the Module
- 5 - Configure the Module in a GuardLogix Controller System
- Setting Up the Module
- Add and Configure the Ethernet Bridge Module
- Add and Configure the 1734 Ethernet Adapter
- Add and Configure Safety Digital Input Modules
- Add and Configure Safety Digital Output Modules
- Add and Configure Safety Analog Input Modules
- Values and States of Tags
- Configure Safety Connections
- Configuration Ownership
- Saving and Downloading the Module Configuration
- Using ControlFLASH Software to Update POINT Guard I/O Modules
- 6 - Configure the Module for a SmartGuard Controller
- 7 - Configuring Safety Connections between a GuardLogix Controller and POINT Guard I/O Modules on a DeviceNet Network
- 8 - Replacing POINT Guard I/O Modules
- A - Indicators
- B - Get I/O Diagnostic Status from Modules in Logix Systems
- C - Specifications
- D - Safety Data
- E - Configuration Parameters
- F - I/O Assemblies
- G - History of Changes
- Index